I ran all of these commands from a PowerShell window. You can run a few quick checks to make sure things are working as expected. Now that the machine is running, all of the Podman commands are available to use. So four steps and less than five minutes elapsed time. You then run podman machine init, which takes a couple of minutes, and then podman machine start, which takes just a few seconds.
#Alterpod for windows download
To summarize the setup process, you download the podman-v4.1.0.msi file and run it, each taking just a few seconds. OK, that's it! That's all the setup and installation work that's necessary to get Podman running on Windows. Until then, you can safely ignore this warning. There is a fix upstream, and it will be cleaned up in the next release. The output above displays a warning about the runtime dir. Entering the command podman machine init will get the machine ready to run. You can call podman help, and it will show you all the commands for Podman, but most of them will fail if you try to execute them now.īefore you can run Podman commands, you need to initialize a podman machine, a type of virtual machine that will give you a Linux environment on Windows.
These commands are not native to Windows without a bit of help. Podman is now installed on your Windows machine, and it's time to run some Podman commands. Opening a new PowerShell window fixed this issue, and it was able to see the podman command right away. It failed, as PowerShell didn't know what Podman was or where it was located. If you watch my video, you'll see I tried running Podman in a PowerShell window, which I opened before the installation.
#Alterpod for windows install
Click on the downloaded file and give it the OK to install when prompted. If you scroll down quite a bit, you'll see an Assets line with an arrow next to it.Ĭlick on the podman-v4.1.0.msi file and download it to your machine. It is large, and there are many notes about it. The first thing to do is to go to the Releases page on GitHub and look for the v4.1.0 release. Install the Windows client in Podman 4.1.0 Prior versions of Windows might work, but you will be treading dangerous water. I did this installation on my Windows 11 machine, and it's also supported on Windows 10. Yikes! You can watch the walkthrough in the video at the end of this article, if you'd like.
However, this time, I amped up the difficulty level by recording myself. The Windows client is available on Podman's GitHub site, so I decided to grab it from there, install it, and do the same things I did in the first article.
#Alterpod for windows update
It is also completely free, as in no cost! Given that, I thought it was time to bring up my old battle cry one more time: "DO-OVER!" and update the article. The setup you have to do to make Podman work on a Windows machine has been greatly reduced. Thanks to Jason Greene's new Podman client for Windows, released with Podman v4.1.0, it's much easier. But you had to do several steps and tweaks to make it all work. After that was all set up, you could install and run Podman within Fedora on Windows to your heart's content. In that article, I talked about how you had to set up Windows Subsystem for Linux (WSL) and then pay for, install, and run Fedora Remix. In September 2021, I wrote an article about running Podman on Windows. A practical introduction to container terminology.
0 kommentar(er)
